Torque Spec

[GCecchetto]

Can anyone with a factory manual for the T600 tell me if they give a torque spec for the bolts that hold the funky plastic valve cover on. I'm working on a by-pass oil filter mount and want to connect to those points to brace the top of the mount.



Thanks



Gino

 

[JPereira]

INSTALLATION - CYLINDER HEAD COVER

(1) Inspect cylinder head cover gasket for cuts and

proper installation in groove. Replace if damaged.

(2) Position cylinder cover on top of rocker housing

(Fig. 22).

(3) Install bolts.

(4) Starting with the center bolt, torque to 24 N·m

(18 ft. lbs. ).

(5) Install breather hose to breather.

(6) Install breather drain hose to breather.

(7) Install breather cover and wire harness clip.

Torque to 24 N·m (18 ft. lbs. ).

 

[GCecchetto]

JPereira;



I'm just looking for the torque spec for the bolts that fasten the plastic cover on top of the volve cover. Is that the breather cover #7 on the list you posted?



Thanks



Gino

 

[JPereira]

I am away from home and do not have access to the manual until later this evening. I will post a reply as soon as possible. The section in question was cut/pasted exactly as it is shown in the manual.

Jeff

 

[JPereira]

I am trying to attach a portion of a PDF. Bear with me as I have never attach a file on this forum. I will try.



See if this helps you...

 

[jwilliams3]

24nm or 18ft lbs.



Justin

 

[GCecchetto]

Thanks for the help guys.



Justin;



Are the new T600 motors built with no gap rings? Also can you tell me is there an air filter that flows better than the stock unit that meets Cummins' spec?



Thanks again



Gino