Torque specs for rocker arms and injector wire nuts....PLEASE

[AMassaro]

I've printed them up a few times from here and of course while I'm in the middle of studding my head, I can't find the paperwork.



Please can someone tell me the rocker arm torque specs and the nuts that hold the wires down on the injectors... PLEASE!!!



I've got time before I re-install them and lash the valves, but I want to make sure I have the right numbers... .



I'm bottom tapping and studding... very easy so far... just time consuming... and I haven't done under the cowl yet as I've just really started on the first few in the middle... those 5 and 6 cylinders look like their gonna be fun... :-laf

 

[RobertP]

if i remember corectly the rocker arm bolts are 27 ft lbs. and the wire nuts are 8 inch pounds. i just normally go snug on the wire nuts with a little 1/4 ratchet.

 

[mattymac]

Just be careful with the wire nuts so you dont twist them off they are very easy to twist off and break.

 

[R_Painter]

I agree be very careful with the injector nuts if you break one no way to fix it other than replace it.

 

[AMassaro]

Thanks for all the replies... 9 hours later and I'm still not done... Have to finish tomorrow morning...

 

[mattymac]

put down the beer for a few hours and it shouldnt be a problem!

 

[AMassaro]

I wish that were the case..... had enough beer over the weekend.