Transmission Pan

[NStates]

I would like to increase the capacity and cooling by adding an after market transmission pan. Looking for suggestions on where to find a pan with a tap for a sending unit. Transmission is the 68RFE.



Thanks



Norm



2008 Dodge RAM 3500 Laramie Quad Cab 4X2



6. 7 Liter Cummins (R) Turbo Diesel Engine, 6 -Speed Automatic 68RFE Transmission, 3. 73 Anti-Spin Differential, Brilliant White, ISSPRO Gauges, Transfer Flow Fuel Tank, PullRite #20,500 Super 5th Hitch, Line-X, XTRA Bed liner , Hayes Genesis brake controller, Custom Graphics, Pull a Mobile Suites Fifth Wheel.

 

[DPKetchum]

Bet there are none available at this time. Hardly anything out for the 6. 7 yet.

 

[Jeff_K]

There was an add for a PML pan in one of the diesel mags I have...



YourCovers.com Products Under Development

 

[Ace476]

I put the PML pan on both my 2002 and 2008 automatics. They have a place to drill and tap for your sending unit or you can have them do if for you. Gives you an extra 3+ quarts. Works great!

Mark

 

[bruiserbob]

Pml Is Great

I just had the PML put on my 2008 Mega 4X4 with the 68rfe auto... . It runs

so cool that I had to check the sending unit with an infra red gun and it was

with 5-10 degrees. It runs so cool it's hard to believe... . highest I've seen

since installing about two months ago is 130 degrees, even when pulling my

trailer which weighs in at about 9K..... well worth the money.

 

[Burner]

What were your temps before the install?

 

[bruiserbob]

Trans Temp

Not sure what the temps were before because I had the Trans, Boost, & EGT

all installed at the same time. Didn't have any baseline readings.