Here I am

TST Box Tips.

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Turbo Air Guide

TST Box mailed Today!

Status
Not open for further replies.
checking for codes?

With my '00 the codes came up with turning the ignition on and off 3 times. As I remember the '03s are different. How do I check my codes?
 
nope, exact same ofr 03's, three times on the key...



And the 5amp fuses DID not help,



I pushed the HP setting up to #5, and then a few minutes later the engine light was on, code P2146 (bank 1 voltage) - could the change in setting be a cause??? time will tell... I reset the codes, and will leave it on 4/4 for a while, (harder said than done)



hmmmm... but truck was still running perfect. I am close to just driving to TST and getting swapping for one of the NEW-new boxes, (not one like mine, very early with BT setting, etc)
 
Last edited:
Tommygun-I think I set a record. Put box on Monday, put new clutch in Thursday. I am trying the new LUK Pro Gold series. Just a little more grabby than stock but not bad. Pedal pressure is the same. I am breakin in new clutch so I going to wait a week before I 9/9 it. :D I also have a code I can't get rid of also but it doesn't effect the performance. Also I believe you can run "out of fuel" with this box. :eek:
 
Originally posted by BillGotthelf

Tommygun-I think I set a record. Put box on Monday, put new clutch in Thursday. I am trying the new LUK Pro Gold series. Just a little more grabby than stock but not bad. Pedal pressure is the same. I am breakin in new clutch so I going to wait a week before I 9/9 it. :D I also have a code I can't get rid of also but it doesn't effect the performance. Also I believe you can run "out of fuel" with this box. :eek:





Bill is the code you can't get rid of P-0336 (crank position sensor)? This is the only code I'm getting on our truck. When this code is on it does not affect the power that I know of. As of now TST is aware of this and is working on a fix. Also if for any reason your remote will not adjust the power setting but will adjust the torque settings check the connection on the red and orange wire's in the fuse box. It seems there is a few small bugs with this box as of right now and its still awesome in my book.
 
Status
Not open for further replies.
Back
Top