2nd Gen Non-Engine/Transmission Vacuum disconnected -where does it go?

[gwizpro]

Hi, I found the problem I was having with No cruise, No 4x4 Drive, No vent controls. There was no vacuum to any of theses. I started at the pump and discovered that about 16-18" from the pump there is a rubber connector. But for the life of me I can not find where it connects. Any help is appreciated and maybe a vacuum diagram layout would help too.

Thanks guys, Snow coming and I need the 4x4 drive. .

 

[ToolManTimTaylor]

Being this is not a 911 post it is being moved to the proper forum.



TMTT-Moderator

 

[nps]

Should connect to a plastic manifold that runs just under the cowl lip that is buried in the large bundle of wires - just to the left of the brake booster when looking in from the grill.

 

[gwizpro]

That was it,

Thanks for the input NPS . LIfe is better now.

 

[TDaub]

After 8 years this post is still viable. Had exact problem.

Found vac line laying on frame rail, would not have found disconnect point if not for this post.



Thanks

 

[CRodi]

It doesn't take much for that line to become disconnected.
I always check it after every fuel filter change, and have always found it disconnected, no matter how careful I try to be.