Ve injection pump

[SAndreasen]

Does any body know if there is a special wrench to remove and instal the bottom nut on the injection pump ?

Thanks Shaun

 

[RWherley]

Its a real pain in the butt, when I did mine I used a regular wrench to get it off by droping the vac pump down and out of the way.

 

[SAndreasen]

Thanks for the reply I use a flex head gear wrench then turn the wench with a small crecent wrench

 

[Bob4x4]

I have one in the bottom of my tool box-been many moons since I have changed out one of those ol boys

 

[Bob Beauchaine]

You can either buy one - (Cummins or Snap On) or make one - just heat the right size 12pt - I don't remember the size - and heat and bend it into a large fish hook. There are "S" shaped wrenches on the markst that others have used that will work.



Bob

 

[Bob4x4]

I remember 13mm I think

 

[WCantrell]

I have an "old" 1/2 inch distributor bolt wrench. It's handle is shaped in an ark and worked well. You may be able to find one a bit cheaper than the "name brand" stuff.

 

[ENafziger]

I think Geno's sells a wrench just for this! Look them up at genosgarage.com

--Eric

 

[HHhuntitall]

I use 1/2". I've got a couple of these floating around... ... can't ever find my Miller/SPX one when I want it... .

 

[Ncostello]

You don't even have to heat the Pittsburgh wrenches to get them to bend like that.

 

[HHhuntitall]

You don't even have to heat the Pittsburgh wrenches to get them to bend like that.

Depends on who was working the day it was made... . I've had some that have just split and shattered like glass, but the majority of them have held up well under a good deal of abuse... . Like last week... I had the box end of an 1 1/4" levered over the open end of an 1 1/8", with a 280lb sasquatch bouncing on the end of it..... It broke the nut loose, but didn't break..... I haven't checked to see how far the jaws spread on the open end... .

 

[Bill Stockard]

I had the box end of an 1 1/4" levered over the open end of an 1 1/8", with a 280lb sasquatch bouncing on the end of it..... It broke the nut loose, but didn't break..... I haven't checked to see how far the jaws spread on the open end... .

Redneck torque multiplier. :-laf:-laf



Bill