Engine/Transmission (1998.5 - 2002) VP44 install in Kent Washington, any takers?

[SMcKay]

I need to replace my VP44 and was hoping that someone in the NW would lend me a helping hand. I would be more than willing to pay some one a good commission to help me.



I have a garage in Kent with good tools and a shop manual, all I need know is someone that has done this and will not mess it up like I would if I tried it myself.



I found local shop to do it for around 300. 00 labor. I would be willing to pay some one half that for some help.



Thanks



SM

 

[DAWG-1]

Pump Change

Hi, Is your truck dead? Can you still drive it? If so e-mail me -- email address removed -- . Sam

 

[SMcKay]

DAWG-1,

I just emailed you, the truck is not dead, and I would be more than willing to drive it anyhwere within 400 miles to get it taken care of.



Cumminsstuff.com wanted around 975. 00 for the VP44

 

[DAWG-1]

Pump

I e-mailed you back did you get it?

 

[DEZLPWR]

SM,

Sam has done a lot of work on my previous '99 and some on my current '98 12v. You will not be dissapointed with his work... .

 

[SMcKay]

If DAWG-1 is Sam then yes I did talk to him. I am hoping to do the install with him sometime in the next week or so.



Thanks for all of your help everyone.



SM

 

[DEZLPWR]

If DAWG-1 is Sam then yes I did talk to him. I am hoping to do the install with him sometime in the next week or so.



Thanks for all of your help everyone.



SM

That would be him... . You are in good hands.

 

[SMcKay]

Just finished the Install last weekend with TDR member n7gxz. Install went well, truck seems to run a lot better but I am still hesitant to get on it until I have a chance to put more miles on her.



Thanks everyone for all of your help and advice, especially Kevin n7gxz.



SM

 

[KYLE4]

Sam is the man. Whats up sam