Engine/Transmission (1998.5 - 2002) vulcan pics???

[Walleye mike]

I need some pics of where to install the big line & lift pump on my 2000 std cab. Any other tips would be great.

 

[DonS]

I need some pics of where to install the big line & lift pump on my 2000 std cab. Any other tips would be great.

If you're asking about the new location for the lift pump (and presuming you're going to use the OEM Carter pump with the end-to-end 1/2" Vulcan kit), I just put the Vulcan-supplied bracket under the existing, rear-most fuel line support. That is, I removed the existing support, put the Vulcan-supplied bracket over the frame holes, and re-installed the support on top of the bracket.



I can include a pic if you like, but I think you won't need one after you crawl under the truck and take a look at that rear support.

 

[Regcabguy]

P.M. sent

I need some pics of where to install the big line & lift pump on my 2000 std cab. Any other tips would be great.

Mike,I p. m. 'd you.

 

[ProspectorTim]

Hey BajaBob, if you have pics send them to me too. I ordered the Vulcan kit last Friday; it should be here by Tuesday.


Thanks

 

[keimmmo]

I continue to stress to check the ID of all fittings you use on the upgraded system. I have seen fittings with only a 1/4 inch ID hole!!! What is the point of using monster lines with restrictive fittings??? I recommend drilling out ALL fittings to 5/16 ID MINIMUM... bigger if possible!



Steve Keim

 

[Walleye mike]

After install 14. 5 idle cruise 12-13 WOT 11, before with a new pump 15 idle cruse 9 - 11 WOT I could pull it down to 5 or 6 before I let off. The standard cab has very limited space thats why i needed pics. The extended cabs have way more room. when I figure out how to post pics, I will.