Water/meth

[Stomp]

Oh man does she go now. Best part is when the first stage kicks on you can watch the pyro go down not up. Now to get the second stage to kick on you have to get about 35-37#'s of boost then the gage goes up, but it stays cooler then it used to. Now my poor clutch is slipping again so its sitting in the shop and I should get it back tomorrow with a luc ceramic clutch. I wanted to get all this done before the first gen party looks like it is going to happen. Now all I need to do is change the oil and grease it and it should be ready to roll on up to Canada. I cant wait to see what it is going to put out on the dyno. Anyone have any guesses. Oh yeah can I run my propane with the water/meth. I haven't tried it yet. Oh yeah I cant keep from pegging my boost gage. 50#'s I think that I am going to have to work over the wastegate, but that might have to wait until I get back from the Party.



Stomp

 

[BPonci]

Your clutch looks great but you need a new muffler bearing cage and collar. I put the old clutch back in with a twice baked t/o bearing. Looks like it will be ready to roll in the am.

 

[Stomp]

Sounds good does that mean it if finished?

 

[BushWakr - RIP]

Hey Stomp,



Just to play it safe... I'll have the tig welder fired up and ready to go so we can weld your head in place before you hit both those switches... . gotta hold the head on somehow right...



pb.

 

[BPonci]

Thats ok Bob i took care of it. (cat cement, j-b weld and e6000 goop)