Here I am

Engine/Transmission (1998.5 - 2002) Westach Fuel Pressure Pegged below zero

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
Yesterday I noticed my Fuel Pressure gauge pegged below zero with the engine running. When I turn off the engine it returns to zero. At a high level look, everything looks connected. Any suggestions? It is just a year and couple weeks old.
 
Double check the ground wire. I had problems with mine early after installation. Make sure you haven't developed any leaks that may cause air to get into the system.



If all looks fine, double check the pressure with a mechanical guage, i. e. , one of BrairHopper's setups.
 
This is cool. I contacted Westberg MFG this morning. Told them my problem and they said it is a bad sending unit and are sending me a new one. No charge to me, they just asked that I send back the bad one.



I like good customer service.
 
Status
Not open for further replies.
Back
Top