Here I am

What Clutch to Get

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

anyone have exhaust brake with G56

G56 Reverse placement

Status
Not open for further replies.
I'm about 20K into my Luk Ceramataulic clutch & already it is giving up to a PMCR & EZ. Never was very good launching from a dead stop either, & worse with a 20K fifh wheel in tow. So... What should I try next? Thought I'd save a few hundred by putting this one in, but now I'm looking at doing it all over. Thanks for the advice.
 
I've got a 3600# southbend DD. I like it. I've never slipped it. It is however very noisy and rough, so if you get one I highly recomend putting a fluidamper on your truck, it is worth every penny. The clutch is also a little harder to push in, go ahead a get the upgraded hydraulics from southbend, it will elminate problems down the road. My DD was/is a little grabby when backing a trailer or trying to ride the clutch to ease in or out of a tight spot, this seems to be getting better with more miles, I only have about 8000 on the clutch.
 
Status
Not open for further replies.
Back
Top