When you insert the key fob in the socket

[PTsideshow]

When you insert the key fob in the socket and start to turn it to on on mine there are two or three lines on wording that flashes on the dash screen, it is so fast that I can't read it. Does anybody know what it says or how to get it to appear?

 

[EDankievitch]

It says Good Luck your going to need it.... Lol

 

[Wiredawg]

maybe "wait to start engine." If its cold enough, grid heater will start and engine warming lamp will light.

 

[Ozymandias]

Take your smartphone, take a video, view it in slomo or frame by frame and you'll know what your Truck is trying to tell you.

 

[Wiredawg]

what if you don't try to turn it, does it display anything?

 

[PTsideshow]

If you leave it in that position, It flashes something in white, but not all the time. Then when you turn the fob to warm/pre-heat it shows the usual symbols and changes to the written pre-heat message then goes off. Haven't had any thing else. And only twice that have had the envelope show up and read them they were no big deals. I was just curious to see if others seen it or knew of it. It has been in for the recalls and it has been Flash updated. When I take it in for the tailgate I will have to ask, they might be able to read it when they hook it up to their computer.

 

[EDankievitch]

When my batts were starting to fail I'd get all kinds of very strange messages while starting. They all went away with the new batts. I think it had to do with low voltage while cranking.