where can i get a 3" wide by 3" tall cast iron lift block?

[2broke2smoke]

that's pretty much it

 

[rfcom]

Good luck with that. I searched high and low and finally ended up making my own. It wasn't that hard and they work very well.



Jim

 

[ToolManTimTaylor]

That brings up a good Q anyhow. How big are theese stockers (I could go outside but ... . )

#ad


You do mean Theese yes? If so Theese guys Or I would be safe and get a Spring Pack made as That 3"+ lift block is going to act like a lever on top of that axle.

 

[Joseph Donnelly]

Another possibility is 4x4 Ford pickups from the 1980s. The 3/4 ton trucks had 3" wide springs.

 

[ctd8999]

Lift blocks

Use a piece of 1"x3" flatbar make as many as you need,drill for center bolt thats all you need. Thanks Steve B.

 

[2broke2smoke]

thanks guys

i just used the bandsaw and drill on the stock blocks



actually worked great as the stock blocks are tapered on the outside but not the inside



took off the top 1 1/4" above the bumpstop



top edge of the block is now about twice as thick as when it was stock