Here I am

Who is using the TST PowerMax 3??

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Group discount?

$ 800 to Extrude Hone an Exhaust Manifold

Status
Not open for further replies.
Interested in hearing from any of you about results on the 01 ETH using the TST PowerMax3.
1. Dyno results if any.
2. EGT's
3. Smoke
Look forward to anything else you can tell me.
Thanks in advance.
Mike

------------------
2001 4X4 ETH 6 spd, QC, SLT,SB, 3:54, Flame Red,camel tan leather, 4" exhaust turbo back, EGT,boost guages, Line-X bedliner.

-------------------------
Project that got way out of hand: total "BOMB"
95 Wrangler 4. 0L, NV4500, Reverse cut Dana 60 rear 44 front, Altas II, Quarter Eliptic suspension in rear, coils up front, Warn 10,000 lb to turn me right side up and the list goes on!
 
Mike. . don't know if the PM3 works on the '01's [haven't checked]... I know the BD4 wire will not. . but I'm sure you went to the site and looked. .
 
Status
Not open for further replies.
Back
Top