will it fit

[DBogo]

Even though i dont have a truck yet im planning for the future will my suzuki Z400 fit in the bed with a stack and a tool box how long is the 8ft bed with a stack and a tool box in it and if any of you have it lets see a pic with a stack and a toolbox how you set it up and do you even think the stack is worth it or just a regular 4 or 5 inch system thanks

 

[bmoeller]

The rear of the toolbox would be about to the front of the wheelwells in the box.

 

[Smitty2500]

Quads are about as long as dirt bikes, I can't fit my cr250 and close the tailgate with a toolbox. Maybe this will help. On another note, I use my gas 94 to haul the dirt bikes. I bought a trailer anyways because the truck is too tall to load the bikes in by myself.

 

[DBogo]

yea then i will probably just put a system underneithe its not worth the tailgate not being closed

 

[CO Lineman]

I had a KFX-400 at one time and have a large tool box. One of the weatherguard toolboxs that take up the front of the bed and when I put the quad in the back I could close the tailgate with no problem. So depending on big of tool box you got, it might fit. On a side note the big quads wont fit in there and close the tailgate.

 

[midlife crisis]

Dont know if this helps ya- my 400ex fits in my SB with inchs to spare. I also put a 4x4 block between the front tires and bulkhead. The rear grab bar is even with the gate, albiet a foot over it. A long bed with a tool box will most probably work out the same, but the stack might cause ya some problems, especially reaching the tyedowns. My . 015--

 

[CEpp]

i fit my prediator in my bed with stacks and the tailgate shut, but i dont have a tool box in the truck. it will fit, but u have have to leave the tailgate down depending on that or how big your toolbox is

 

[Straight6Jeff]

My DR 650 will not fit witht he tailgate closed. I do not have stacks, but I have the wide Weathergard cross over box. It misses by about 10 inches.