xfer case boot assembly

[Bartlett]

Anyone know how to remove the transfer case shifter boot assembly from the floor of the truck?I dont see any screws or fasteners holding it down. I dont want to have to get out my really big pry bar either I want to remove this so i can see if i can run cb antenna wires through there.

 

[steved]

Basically, grab the part closest to the seat and pop it up out of the plactic... I had to do it with mine... there is a tab you will bend back when you snap it back in place. It hooks under the console at the front and "rocks" into place... being held in place with the tab.



steved

 

[RHildreth]

Ditto on the instructions. My boot was squeaking really bad, I had to open it up and spray silicone inside. It's been quiet since then.

 

[Bartlett]

Ok I will give that a try. Thanks,

mike