Here I am

Power Adjustable Pedal no power

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Question for you dually guys (and girls)

Seat cover

Status
Not open for further replies.
My power adjustable pedal doesn't work. Checked No. 32 fuse @ the fuse box, tested sat. I also checked the connection behind the switch. Harness is properly plugged in to the switch. Anyone here encounter the same problem?
 
Last edited:
My power adjustable pedal doesn't work. Checked No. 32 fuse @ the fuse box, tested sat. I also checked the connection behind the switch. Harness is properly plugged in to the switch. Anyone here encounter this same problem?



No but I was just looking at the wires on the back side of that switch as a source to power my radar detector and learned a couple of things. This is on a 2007. 5 so not sure if it will be the same on a 2006. The switch is powered up when the key is inserted into the ignition, it doesn't have to be turned to on or accessory just inserted. And then there is like a 5 minute delay before the power goes away from that switch after you remove the key.
 
Last edited:
THANKS! I'm going to access the wiring at the back of the switch. I was able to get hold of the electrical schematic drawing of the switch and test for 12vdc to power up the dc motor.
 
Status
Not open for further replies.
Back
Top