Here I am

2nd Gen Non-Engine/Transmission 2001 Dodge Ram 2500 6 speed engine stalls when stopping

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

2nd Gen Non-Engine/Transmission Brite Box and headlight Issues

Status
Not open for further replies.
2001 cummins 5.9 HO 6speed truck has a weak start but starts every time push in your clutch put it in gear and start to drive down the road runs and shifts fine through all gears coming to a stop light if you hold your clutch down to attempt to stop the truck gets an erratic idle and then dies or just dies with out the erratic idle i did experience water in fuel when I bought the truck. VP44 is almost new has a phatshaft 75mm turbo fass 220 snow meth kit it's not hooked up when I bought it but was previously hooked up. Head studs and fire ringed I'm kinda new to the mechanics of a diesel but do great with gasoline engines any help would be appreciated thank you and god bless
 
Need to put a scanner on it. Seems like you lift pump isn't getting enough fuel to the vp44 pump. Or the ECM isn't setting the idle right.
Don't how much extra power the meth would give you but just running diesel mite not lite up the turbo enough when coasting to a stop.
If you do not have them Exhaust temperature gauge and boost gauge will let you know what going on with the engine/turbo.
 
Last edited:
According to the programmer it runs about 30 psi at idle. And around 20 at WOT


30 psi is too much. What lift pump do you have, can you adjust the psi? If so, I would turn it down to about 18 at idle. Do you know where the monitor is reading the psi? What programmer do you have?

Nick
 
It's a fass 220 not sure where it's reading from. I have a edge juice with attitude programmer. Also not sure if the fass is adjustable
 
Status
Not open for further replies.
Back
Top