Recent Content by ABarry

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. A

    connector ?

    Thanks for the replies... seems that a squeeze and pull and it came right off... much easier than expected
  2. A

    connector ?

    Question- I need to disconnect and reconnect this a few times most likely. .. However I do not want to break it.. I have had limited success in the past not breaking.. If i understand correctly the tab in the middle would pull up and then it should come apart? Thanks....
  3. A

    Tach problems on 06 Ram

    put me down for another 06 bad tach... Happened around 65000
  4. A

    Third Generation Jake Break Problems

    Mine just failed at 53K bearing went out. . Bypassed with non jake brake belt before it let loose. new pump from Geno's. . $359 Dealer $1200
  5. A

    Looking for a good write-up w/pics for rotors/pads

    ok. . well I just paid a few bucks for the new pads? I sent Geno's and email. . see what the deal is?
  6. A

    06 3500 Caliper removal?

    Thanks for the replys
  7. A

    Looking for a good write-up w/pics for rotors/pads

    3. a short pry bar will remove the caliper from the bracket. don't worry about bending the clips, new ones come with the new pads. I just got the new Hawk pads fro Geno's... . No clips?
  8. A

    06 3500 Caliper removal?

    Ok. . maybe it different on a 2 wheel drive? I look like the bottom of the caliper may want to come out first? Kinda wierd setup
  9. A

    06 3500 Caliper removal?

    I know it "should be easy" but it is not? I pried on it a little but it did not budge? Where do you pry?
  10. A

    06 3500 Caliper removal?

    Quick question... How does the caliper come off to remove and change the brake pads. . ? Do you pull those clips? On my 94 you just lift the caliper up and thats it... THanks for the help
  11. A

    Looking for a good write-up w/pics for rotors/pads

    Did you ever find a good write up? I went to do mine today and could not get the caliper off. . ? It appears that there is a metal clip that holds it on once the bolts are out? Came right off on my 94 the 06 is different... How do you remove the caliper?
  12. A

    buying a 2006,what are thier weak points?

    2006 Seats suck, Blend-door brakes , dealer covered both under warrenty more than once for me... 35,000 miles. .
  13. A

    3rd gen seat fix w/link to pics

    My seat failed at 30,000 miles. The metal is poking through the seat cover now. Dodge is replacing under warranty. The welds on the seat frame are sharp and cut the foam over time. Right now its like sitting on a sharp metal bar. . WTF
  14. A

    Thinking about a 06 mega cab

    blend-door is a problem. . ask if it has been changed
  15. A

    Engine/Transmission (1994 - 1998) 94 fuel leak?

    still have not fixed it. . thanks for the tip's
See more
Back
Top