Recent Content by kleinschmin

Yes it is reading true temps and it will pass smog!

He led all the harness found no problems. Disconnected the batteries, then unplugged connectors at PCM, they did not seem to be very tight. Applied dielectric silicone on connectors. Tightened them up reconnected batteries. Cleared codes and we seem to be good to go. Thank you. A new PCM would...

I will tomorrow thank you

Still get -40 do you think there is an open or the PCM is bad?

I will try that

2004 3500 quad cab 5.9 automatic Replaced sensor twice to no avail. OBD reader says intake air temp is -40F. I live in the Mojave desert. Any ideas?

Don't forget the special days and never take her for granted. Always open the door for her. Never hide anything from her this is your friend for life. I hope this will help you.

I will have to look up what you wrote. Thanks... ... ...

Yes, I am still in warranty. Unfortunately our local dealer closed up. Have to go 90 miles, that is why I pulled the tank. I wasn't sure i could get there. I am going to call them Monday on it. Thanks for the reply.

A fuel gauge is next on my list.

I finally had a chance to drop the tank. The filter screen and interior of the well of the fuel pump were plugged up with what appears to be thin sheets of plastic. The baffle in the tank appeared to be coated with the same material on the lower half of it or it is coming apart. Has anyone...

I too would like manual hubs. I have laways had them on all my other trucks and really enjoyed using them.

My 04 3500 Quad cab 4x4 automatic 5. 9 HO died again today. This started back in May. When it dies normally I can pull over and prime the fuel filter by turning the key for 30 sec. s. Most of the time I do this more than once. Then it will restart. Some times it will keep running for along time...

I have cleared all the codes. I did turn on the key to actuate the lift pump and inspected the fuel system could not find any leaks. i have not checked the relief valve yet. i will do that tonight. Since clearing the codes I have driven it another 100 miles with no problems. Thanks for your ideas.

My truck died Sunday. After priming the filter I was able to get it started again. I was able to pull the following codes P0088 fuel rail pressure signal above maximum limit, P0148 high-pressure common rail (HPCR) check sum and P0483 fan speed. This is the second time in 2 weeks this has...