Recent Content by paniolo

thanks for the info. i messed up looking at the picture in Haynes manual. and reading the general info on alignment. i adjusted the tie rod adjuster tube next to the driverside tire. the instructions should have said drag link adjuster tube.

Is this correct per instructions of track bar retrofit bracket. "steering wheel re centering adjust the split sleeve on the tie rod adjacent the pitman arm if wheel 2 left shorten if 2 right lengthen tie rod. " would'nt that adjust toe in? my truck is 4x4 3/4 ton 02. or would you adjust the...

thanks guys. i think i'll take it to a alignment shop. i noticed black tread makes in the driveway and scuffing on the outer tire.

i installed the adjustable 03 track bar. when they say center axle. does that mean centering the pumkin to the curve in the bar? also to correct the steering wheel i got it to center but on a turn the wheel seems to pivot (over steer) should i back it out to the opposite to return the steering...

thanks for da replys. got a FASS 150 on order. i think thats rated at 17psi.

after a hard accelaration, if i let off the gas suddenly the motor will die. won't restart unless i crack and bleed the injector lines. i got stock and bd pusher pump with good pressure 20 at wot. is the problem air in the line? would i be better off with an airdog?

What a difference the manifold makes. It makes the turbo spool up a lot faster. And the egts are supposed to be lower.

Thanks for da replys. One port has my gauge thermocouple. I'm installing a K type probe for my water methanol set up. Hope I could use a reducing fitting at the other port that will work 1/4 to 1/8. to make things easy. I tried tapping into my gauge but it did'nt work. They say if I have a...

Not sure if I got BD, ATS or other. But kinda sure there the same. Any way mine has two. Are they both 1/4 or is one 1/8? Its hard to tell right now cuz the manifold is upside down with the twin set up. And it's real HOT!

I wuz thinking of getting da enviro guard kit. But a friend did'nt recommend it due to my 50 lbs. of boost.

But will a 1 3/4 fit over a 2 1/8 OD hose? Tried several times calling Spectre Performance but no customer response.

been there done that thanks. I've even called them several times and even left messages. No return call, nothing. On their website only shows 1 3/4. Good luck to them. They suck. oops not Jegs. But Spectre Performance, they got problems.

been there done that thanks. I've even called them several times and even left messages. No return call, nothing. On their website only shows 1 3/4. Good luck to them. They suck.

OD. 2 1/8" ID. 1 3/4". Been looking for stainless braided hose sleeve myself. All are too small. Gonna check local hose shop next.

Installed mine ah couple weeks ago. 02 6spd. went to Radio Shack got a automotive round approx. 1/2 in. round rocker panel flush mount switch. There is a wire going in coming out of the clutch pedal position switch inside the cab at the top of the pedal arm. I tapped into the hot one ran the...