Recent Content by Rosshatfield

I did clean all of the conections at the drivers side battery and no differnce. I have made the mistake of ordering the relay from Dodge! But next time I will know better.

The Selonoid dosn't pick up all of the time. I have a new relay on order so I am hoping that will solve the issue.

This problem is driving me crazy! I have a 95 and it start spuradically. Sometimes it start right away and sometimes it takes 10 try's. I have replaced the Shutoff selenoid, and the starter contacts and still same problem. I am sure its something simple I just don't know were to look. Please...

Ronco, Usually at or above 60. My boost climbs but my accelleration doesn't. I think I just need to take that final step and intall the plate.

Has anyone had this issue. I have a 95 when I am backing up or if I pump the brakes the brake and abs light comes on, the pedal gets hard and I loose my breaks. Do I have a bad vacum pump?

The TV cable ties into the throttle linkage at the pump. Where the cable runs through the bracket the TV cable is adjustable. There is a release button that allows you to run the cable forward or backward. Pull out towards the rear of the rear of the truck, it makes the shifts later and firmer...

I did recently replace the TPS becuase it was kicking in and out of lockup. The problem I am having with it not kicking out of od when trying to pass or climbing a hill is something that it hase been doing since I bought the truck. I did adjust the TV cable abour a 1/4 inch towards the cab. I...

The TC locks up fine and stays locked. The OD light is acting normal.

I have a 95 with an automatic. It does not want to kick out of OD when I am at cruising speed. It is frustrating when I am pulling a hill or need to pass. If I romp on it, it kicks down for a second and then locks back up. I have tried adjusting the TV cable back. I like the way it shifts now...

Does anyone know of a good dodge mechanic in the Santa Barbara, CA. area? Just moved here from Oregon and there doesn't seem to be to many deisels running around.

Thank you for your info. I appreciate the input it is nice to hear anything that make the process quicker and easier.

What do the valve cover bolts need to be torqued to and are there any potential problems I can run into when I change the gaskets? Thanks for any help.

I have a 95 2500 4x4 with an automatic. It makes a very annoying sound whenever its under a load. If I am climbing a hill or just have my foot in it I can hear a rattle coming from the Tranfer Case. I goes away when its in 4 wheel drive or when I put pressure on the 4 wheel drive shifter. I have...

my brakes are not working in reverse. The brake light and abs light come on when I hit the brakes while backing up. Also the brakes will go completely away. The peddle gets hard and the brakes fail. Once I go a few feet forward they come back. I have not found an obvious vacum leek. I have bled...

My 95 2500 is having brake issues when backing up. The brake light and abs light will come on. The peddle gets hard and the brakes fail. Once I strart travelling forward the problem goes away. Any Ideas?