Recent Content by Sneaklylilpetey

Well I disconnected the harness and cut back about 2 feet of the plastic wire protector and inspected all the wires with my flashlight. I couldn't find anything wrong with them. I then took some electric connection cleaning spray and cleaned out both ends of the plugs. Looked for bad pins but...

I've been getting the P2121 code for awhile now, did the obvious and replaced the pedal but it came back. Today I decided to dig into it with an article I found to check the voltage. With my scan tool the voltage is within spec at all tests however when I go under the hood and wiggle the big...

I'll give it a try thanks

Bad stabilizer bushings would make a clunk sound when going over bumps? I don't see how that would clunk

Yes

Both of them look like that

Good idea. I think it's my lower ball joints..

Personal preference.. We all have different tastes.

Something is still wrong. Either a ball joint is bad or it's still hitting the strut tower. If I go over a bump I hear a clunk. Mostly on passenger side. All the ball joints were replaced last year. I need to find out the clearance range for this upper control arm. I wonder if it's still...

Took the larger springs off and put stock springs on, problem solved. Maxtrac is working with me and letting me return the springs. Heres a pic. 2.5" blocks in the rear and 3.5" longer spindle arms in the front.

I'm taking off the bigger springs and putting the stock springs back in. That will take it down to a 3" lift. Hopefully MaxTrac will let me return those springs since the kit really doesn't fit on this truck.

Yes, I thought the same thing. It would move up with front end weight The maxtrac kit comes with longer spindle arms and larger springs.

New moog control arms are on and it makes no difference... Control arm is still hitting the strut frame.... Really starting to piss me off....

I measured the height of the front and back and the front is sitting up 1 inch higher than the rear I went ahead and ordered some Moog upper control arms. I have a feeling it's these cheap Detroit axle control arms

Only thing I can think of is that those are cheap aftermarket upper control arms. That might be the issue