Search Results for Query: *

Does the manifold heater cylce once it starts ? I had 1st generation that chugged and smoked just plane didn t wanna run becuz the grid didn t cycle once started

hey 2nd time do you want pcm or the one on the engine i have an engine puter for early o1 not sure if it would work for u prolly not but just thought i d throw it out there

injectors for sure they seem to really give me a longer power band

i have another carter fuel pump by tank with pre filter ,which i should change but just haven t . been to cold to even wanna drive it lately here in mn since only drive 8 miles to work . But goona do it this weekend have to haul another truck have to see what happens then. thanks

My 01 feels like it bucks between 1600 -2000 RPM under load it has slowly gottin worse over the last 10000 miles now feels more like miss especialy pulling . Fuel pressure never goes lower than 10 but i do have 22 at idle use to have 27 ,is that to much? No codes just worries of pump failer...

Ya i think those have been on there forever to i think there was more i should of wrote them down

Another problem its not my week My brother just bought a 1998 put a super chip program on it on the high but not to impressive setting but it ran fine . Than he put it on the tow mode and every thing went wrong wont run and no ecm reading on scan tool does this sound like he needs to get...

ya codes i remeber were 500,1693 i should of wrote them down i have an extra pump in the truck it happened saturday night and there was another guy running with me so i rode home with him will be back out there in a couple days to get fixed or haul home

truck died won t start anyone no of a good shop on I 94 around exit 66 in michagan or a place i could leave for a few days . I live in mn any help would be awesome

Hello my bro also has A 06 that just had #4 line break we peplaced it and then the truck wouldn't run hardly at all. We took it to the dealer and they got it to run,but of course the tech wasn't there to tell us what he did. We then noticed that it smoked and now it is missing and has no power...

pinion gear lost a tooth and recked tone ring. New ring and pinion and tone ring and as good as new

Speedo works fine up to 30, any faster than it gets lazy and jumps around have replaced speed sensor in rear diff and and didn't help. I than viewed the signal on a scan tool and that also jumps up and down thinking maybe a wiring problem, or maybe the tone ring any info would be helpful thanks...

Was just the pilot bearing,order new southbend clutch and have to put new input seal in

Mine sets the same code also when its really cold and i have to crank on it more to start. I also have gotton a low battery code once. The troubleshooter on the scan tool i used said to check grounds also. it hasn't bothered now since its warrmed up either for me. I'm going to put new bat...

Hey new guy here was wondering what you folks think my problem might be. When idling in nuetral i have a slight vibration but it goes away when i depress the clutch and now i can slip my 35000 mile ago clutch if i want too,and if i push the shifter farther than i need to in 5th it feels funny