Here I am

Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. M

    Archived Help

    I would check the lift pump on the side of the filter housing. sounds like it isn't pulling fuel to the cp3 pump. Should set a code but no light.
  2. M

    Diesel Power Magazine Shootout

    You need to spec out similar trucks. You can't compare towing with a 4. 30 gear to a 3. 73. Ford offers the 3. 73, why wasn't it tested? I too think there was some bias there, but you'll have that. I would like to see some tests on longevity. Most 6. 0 Fords haven't made it out of 3/36 with out...
  3. M

    Gooseneck V.S. Fithwheel

    I pull the rail pins out and leave my 5th wheel hitch hanging on the camper until next trip. Saves the back and I don't have to store it.
  4. M

    What is the sound I hear with key in ACC position?

    The clicking sound is there with any common rail cummins when the key is turned on to acc. The injector solenoids cycle and will eventually time out if you leave the key on long enough. No big deal, don't panic.
  5. M

    2006 engine damage - Dodge will not warranty

    It does sound like an injector failed. I have replaced two '03 engines for this problem. The solenoid on the top of the injector cracks where it is bonded to the injector and fills the crankcase with fuel in a hurry. You will notice it on your tailgate going down the road from it blowing fuel...
  6. M

    Cummins' scantool thingy ????

    cummins cannot scan a 3rd gen truck. You have to use the DRBIII at the dealership.
  7. M

    Looking for opinions for new CTD

    I had a '99 truck and just went to an '05 dually and love it. Big difference in the trucks. The new 6 speeds how ever aren't over driven as much as the autos are. The 48re is overdriven approx 30% where the G56 is only approx. 20%. This is why you can't get the 4. 10 gear with a six speed. The...
  8. M

    Head bolt problem

    head bolts I wouldn't be overly concerned as long as a cummins head gasket was used. I was told by cummins that their stock gasket was good for boosts up to 65psi. I am currently boosting 52psi and am running their gasket with arp head studs. 28 psi shouldn't even be close to what a stock head...
  9. M

    comments on ATS trannies

    I installled an ATS trans in a friends '99 cummins truck. I am a dealer tech and build transmissions on a regular basis but they said theirs would be no comparisson with unlimited horsepower. We bought the $5200 trans and installed it for the purpose of truck pulling competition. The trans made...
Back
Top