Search Results for Query: *

If you check out full throttle suspension they will sell you up to a ten inch spring. You have a lot more work ahead then you think. Any lift over 5 inches is going to need a trans drop and or a new front driveline made, around $800 for a high angle cv setup. I personaly have a fabtech 5 inch...

should fit with no problem will have to make a mounting plate the truck comes with 6x9s in the front doors Make a plate to cap the hole and mount new speaker on that

I was told the hot juic ealso increased the fuel rail pressure I have been running both units since i got the juice when it first came out in feb. Ben running with the ez on three and juice on three intill the hot juice I have been driving on two and two I am sorry if I was wrong just going...

Got to be carefull I just installed my hot juice and after about a week of normal driving Hot juice on 2 ez on 2 I found the oilpan full of diesel. #4 qnd 5 injectors went bad and filled her up. I dont think the stock injectors can handle that much pressure from both juice and ez

It is about 6 to 7 inches just enuff to clear the frame and transmission

I just installed the 5" magnaflow system about two weeks ago. It is a little louder in the cab but a huge difference outside very loud. The setup does get rid of the cat, could probably be rigged up in there some way but why, that is the reason i went with the magnaflow is it was a turbo back...

It is toooo easy to spend alot on these trucks edge ez 500 edge juice 800 Tires 1000 Lift kit 1200 Flairs 500 Exhaust 1000 Wheels 1200 Intake 300 Tint 250 Kodiak steps 1800 _________________ total 8550 Thats all I can think of right now

I have an 05 with juice/ ez stacked on it. I love the power but the other day I was getting on the freeway and was on it pretty hard I guess it was holding around 38 to 39 psi when the right side endcap blew off of the intercooler. Has anyone else had this problem and are there any fixes besides...

Looks good That really looks good. Just one ? though did you have to drill into body area or just in the wheel opening area? I have the bushwackers and they dont sit real tight against the body but I do not want to drill the fender.

Those calcs seem pretty close I have always used this formula take the 265/70/17. There are 25. 4 mm in an inch so take the width of 265 and multiplyby . 7 then again by 2 then divide by 25. 4 then add your rim hight of 17 and that should also be close 265 x. 7=185. 5 185. 5 x 2=371 371/25...

I have known of Dana for a while and some may call hom a kid but that kid has built some of the fastest street cars on the west coast. I remember him being fresh out of high school and building the worlds fastest mini truck. There are not to many people in the Vegas high performance seen that...