Search Results for Query: *

You The Man. THANKS! And I f not to Pushy. Length of "U" Bolts, I need to get a set made

I am in the process of installing Factory Overload Springs. Anyone have a picture(s) of an OEM truck Spring pack. I want to make sure I get the parts in the right Place/order. Thanks. . ( I got the 'stops' figured out :) )

I intend to leave pump on truck and pull the screen,,

Anyone ever here of a " MEXICO " Built engine with a bad KDP ?

run out of fuel

OK, Found the screen ( reread all links, found picture ) Now, How do you clean the screen ??? It does not appear to be removable, from the small Nut...

Specific Question, Where is the screen??? I have read the other links on the Forum but I am still confused... Is the screen in the Pressure line Fitting ? If I remove the pressure Line will I see the screen in the fitting, or Do I need to remove the regulator piston to get at the...

Jeff, Thanks for the replies...

How can you tell an old cover from a new cover ??? Why is the new cover OK... . What changed ? And , Any Mexico Engines affected??? I know, lot's of questions, But , owning an 02 , I find it hard to do the KDP for a remote " 1 of many good " problem.

what block casting? any other data ???

3148 Hic Cup !! Sherries at 10

Damage diff ? Don't know, But why not get new tire to Match the spare tire, And use the 50% tire for the spare.

So, I assume the emergency brake function is lost over time... . As I don't think it can be recharged ... Wonder how many BURBS it takes???? to be empty...

MAJOR UPDATE: Leak Fixed it self !!!!! ??????? RECAP: PS Fluid had run down onto the Electrical Harness , down to lowest point and than dripped onto the trac Bar. Ran down the trac Bar to Passenger side attach, than onto cement driveway ,and ran back behind wheel to form a 8 “...

Thanks, May install a cooler anyway, can't hurt living in Florida.

?? grid heaters cycling on/off when cold, it's normal..... Should be steady Voltage after truck is Hot, Also, you need a good Voltmeter to verify Voltage of Alt...

Ref Previous thread : No steering... PS Pump is leaking at the seal ( Empty overnight ) I see in the manual that they instructions say to remove Vacuum/PS pump asm. Can the PS pump be removed without removing the Vacuum pump? The coupling on the PS Pump, Does that have to be moved...

LEAK, Looks Like the PS Pump shaft seal blew out, Leaked all the fluid out overnight. BUMMER, OK: 24V Guys, can I get the pump off without removing the vacuum pump... ????

Thanks, searched yesterday, could not find this post. This is great, Questions? My pump is behind the vacuum pump ( I think ): Do I remove the whole asm. ? or just the Pump Part ? If I Get a new Pump, is there a high pressure pump available ??? At 90 K I might just change the pump and...

Follow up: Left truck in Sun with Hood open, Now 60 degrees... ... Removed PS Filler cap, Fluid Level OK, Started truck, No steering, NO Movement of fluid in PS Pump, PUMP INOP ??? Went to get Flaashlight, Look in reservoir, Fluid movement... . PS Works !!!! OK, What was wrong, Is...