Search Results for Query: *

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
  1. B

    Check engine light after battery replacement

    Old post but same thing just occurred to me. The cel auto turns off after three run cycles after problem is corrected. (low or no voltage.)
  2. B

    Serpentine belt, idler pulleys, etc.

    Missing one rib.
  3. B

    Serpentine belt, idler pulleys, etc.

    Thanks for the replies. bg
  4. B

    Serpentine belt, idler pulleys, etc.

    120000 miles, all original parts.
  5. B

    Serpentine belt, idler pulleys, etc.

    I am at point where my serpentine belt must be replaced. What is consensus on going ahead and replacing the idler pulley, fan bearing water pump, etc?
  6. B

    What antifreeze is compatible with the Mopar that it came with?

    Thanks to all. BG
  7. B

    What antifreeze is compatible with the Mopar that it came with?

    Antifreeze recommendations?
  8. B

    Stock fuel filter screw on cover

    Well, I changed the filter, put cap on and tightened as tight I thought was good and I could still see the "O" ring, tightened some more, looks good. Guess I was fortunate it failed at home. (It didn't fail, I just failed to tighten it right the last time.) The filter housing is kind of like the...
  9. B

    Stock fuel filter screw on cover

    As fine as the threads are I doubted it possible? It did start to leak and has about 10,000 miles on filter. I must have turned it 3/4 of a turn till it got tight. Haven't driven truck since. I am going to go ahead and change the filter and look at the cover real close. Thanks for the replies.
  10. B

    Stock fuel filter screw on cover

    06 3500, anyone ever had the fuel filter cover unscrew enough to cause it to leak?
  11. B

    Underhood insulation

    Thank you Oz
  12. B

    Underhood insulation

    Is there a solution that works to get the insulation back in place or what are the consequences if removed all together?
  13. B

    Air line connection leaks on exhaust brake

    Yes, the first two sets were stainless steel.
  14. B

    Air line connection leaks on exhaust brake

    I just cut the line with razor blade and installed, I will make sure no burrs this time... got new fittings in ail today. No sleeve. The compressor is rubber mounted, vibration may be a factor. Thanks for the replies.
  15. B

    Air line connection leaks on exhaust brake

    The push on fittings for the 1/4" plastic lines on my exhaust brake continue to leak. Replaced them with original type and still leak. anyone find a fitting that will hold air for a while?
  16. B

    Custom Flow Tail Gate Installed

    Nice gate, I had the PVC one and it finally disintegrated, it wasn't much to start with.
  17. B

    Rear seat stuck in up position

    There is a write up on here somewhere if you can find it about solving this problem. bg
  18. B

    Have you had a chipped key go bad?

    Thanks for al the responses, I discontinued the use of this key. It is possible that it is not a chipped key. If I find that to be true I will respond. bg
  19. B

    Power seat repair

    I did the rear on mine last year, I bought both front and rear motors complete and intended to change both but it ended up being so haphazard that I just replaced the one that had stripped the gears. (The parts from Genos are top notch) The complete motor is the way to go. I had trouble getting...
  20. B

    Have you had a chipped key go bad?

    I have been sitting around last few days with heating pad on my back..... Wonder if there could be EMF from that causing problem with key?
Back
Top