441/865 W/m

[Bob Beauchaine]

Ran at Meridian ID on a Dyno Jet -5/19/07 and put down the following numbers. On #2 381/760 and with W/M 441/865 Oo. Oo. I used a mix of 50/50 W/M with my Stage 3 controller was set at 100% and the pump at the stock 150psi setting. I had 1 W/M injector leaking so there should be a little more there. Needless to say I am very happy with those numbers.



Bob

 

[Niki]

Good #'s, especially for an HX35.

 

[daledozer]

How many holes are in those injectors and what size holes are they, ex. 4x12, 5x12.

 

[Bob Beauchaine]

1 injector is . 375 and the other is . 625. - hope this helps.



Bob

 

[PToombs]

Bob, I think he means the DD3's.

 

[daledozer]

What I meant was how many holes in the injector tip, and the size of the holes, I do not know what size a DD3 is, for example I have a set of 435s, each injector tip has 5 holes and the hole size is . 014.

 

[Bob Beauchaine]

Sorry about ther confusion regarding the injectors. All I know is that they are 2nd Gen injectors adapted to the smaller high pressure lines on our 1st gens. They are honed DD3s and they work quite well. Now for the bad news - from what I understand a set now will cost you $1200+ for a set. To the best of my knowledge there were only 2 sets made for 1st Gens. Mine were the 2nd set which cost me $700 for the set. That's when the price went to $1200.



Bob

 

[daledozer]

Just curious, running a similar set up as yours, good numbers.

 

[sdstriper]

daledozer, what turbine housing are you using with the HX40? Also is it a Super 40?

 

[daledozer]

16cm, just a standard 40 I get about 40-45psi.

 

[bgilbert]

and to hijack

16cm, just a standard 40 I get about 40-45psi.

Dale, where did you come across that rare piece, the 40 with a 16 housing?



Bob you'd really see a HP jump if you ever jumped a charger size thats for sure. Keep up the good work.

 

[daledozer]

Bill, it's really rare, give you a smokin deal on it for $600.