I recently put a screw through the gas tank on the top-front where it is directly below the rear seat.
I would go with the TF 54 gallon replacement but am not sure as to whether it would fit. Before people start saying that it would I should say that the floor under the rear seat has been pushed down about 2 inches to allow four 10's to fit under the seat while keeping the seat at factory specs. So as of right now the sheet metal sits about a 1/4 inch away from the factory tank at the top front corner. If the TF is no closer than the factory at this point than I will gladly go with it, but suspect due to its size and the fact that the top-front corner is square versus rounded on the factory, that I will not have room to accommodate it.
Can plastic tanks be sealed? Does the TF tank have factory clearances between itself and the body? Anyone know a fuel tank fabricator in the Seattle area?
Also let me know as to whether those swapped out factory tanks are for sale and what ya'll would like for them. Thanks

Can plastic tanks be sealed? Does the TF tank have factory clearances between itself and the body? Anyone know a fuel tank fabricator in the Seattle area?
Also let me know as to whether those swapped out factory tanks are for sale and what ya'll would like for them. Thanks