Best Turbo for my Manual 5 speed truck ?

[madmac74]

I attempted a search but could not find an answer or reccomendation. I tow and haul regularly and its daily drivin.

any Ideas?

Current Set up on my 1994 2500;
WH1C Turbo with 62 mm comp. wheel / 13cm Turbine
40 hp injectors, valve springs, maintained Full K&N air filter system, Pacbrake Exhaust Brake
Boscch 7100 with 6 degrees advanced timing and a #100 plate.

Any and all advice would be greatly appreiciated .

Thanks in advance
Parker in Prince George

 

[BigPapa]

I like my HE351.

 

[GAmes]

40HP injectors means nothing. Hole size, spray angle & number of holes? 6 degrees advanced puts you where? How much do you want to spend?

Ever done an oil analysis with that K&N?

 

[ROADWARRIOR]

How does your HE351 compare to the stock HX35?

I ran a PS62/12 with my 5 speed, 4.10 gears and 100 HP injectors along with a Scheid street cam. It was really nice for fun driving. But I ended up returning to a stock HX35 for better towing on the numerous hills around here. The HX35 spools so much sooner in the low RPM range it was like getting an extra gear down low. Made towing my tractors much easier in the hills at the typical 45 mph speeds around here on the hills and curves. With that said, I really miss my PS62 for passing and all around top end power. This is on a '99 24v.

 

[BigPapa]

How does your HE351 compare to the stock HX35?

It spools quicker and cools better towing than the HX35. I towed @ 10K a week ago. I’m in TN so lots of hills, AND, I was following a fellow in a Ford that was scared to go the speed limit, and never got over 1200*.

 

[Joe Mc]

Try giving the folks at High Tech Turbo a call
https://www.htturbo.com/
Tell them your rig, present setup and what you'd really like/want/need and they should be able to steer you in the correct direction for one of their on the shelf units or custom build (stand by $$$l that'll work for you. I've been very pleased with the 64/14 WG I got like 15 years and 120k+ miles ago. The 64/14 (a.k.a. was known as super street turbo) met what I was looking for. Most likely not for you tho, I don't haul anything except my 170# ass, outside of an occasional car on trailer.

 

[madmac74]

Thanks for the replies . just getting back into life here after Covid..

 

[madmac74]

40HP injectors means nothing. Hole size, spray angle & number of holes? 6 degrees advanced puts you where? How much do you want to spend?

Ever done an oil analysis with that K&N?

Appollogies GAmes. The previous owner did all of the mods on my truck and his dyno sheet showed 285hp and 770ft/lbs torque. And no I haven't done an oil analysis ...good idea
P