Carli ball joints arthey good bad -can you service them

[DougMutimer]

Are carli ball joint good can they be serviced

 

[ranger 393]

Yes, I just replaced mine with them. If I had it to do over I would make the same choice. Just my .02
Tdr issue pg 16 has an article on ball joints.

 

[S.Morris]

I also have Carli BJ's installed several years now (one of the early sets after mass production finally started). They have performed well and are greasable (use only their spec'd and supplied syn grease)

However I have also installed a few sets of Dynatrac BJ's in other (company trucks) that see more severe use than my personal (sig )truck. They have also performed well and at a cost of 25% less , if I were to do my own again I would have installed Dynatrac.

 

[brods]

https://www.turbodieselregister.com/threads/250313-Carli-Upper-Ball-Joint-Service-How-To

 

[Regcabguy]

I also have Carli BJ's installed several years now (one of the early sets after mass production finally started). They have performed well and are greasable (use only their spec'd and supplied syn grease)

However I have also installed a few sets of Dynatrac BJ's in other (company trucks) that see more severe use than my personal (sig )truck. They have also performed well and at a cost of 25% less , if I were to do my own again I would have installed Dynatrac.

I was fortunate to get in on their $200 rebate+a group buy. The shop I use installs them every week. Once in a great while I luck out.

 

[DougMutimer]

Thank you i will check out the dynatrac-b , j