Engine/Transmission (1998.5 - 2002) Clutch Going???????

[PSL53]

I have 103,000 on my 5 speed and just recently I have had a problem with getting the shifter into gear. It doesn’t engage smoothly and takes a couple of tries. Going into reverse is really hard. Is there a South Bend in my future??? Does anyone know who installs them on the western slope of Colorado, hopefully around Glenwood Springs to Junction?

Thanks

Peter

 

[PRout]

Sounds like a possible pilot bearing problem.



At around 90k mine got gradually harder & harder to shift, to the point where 1st or reverse were almost impossible to get in gear at a stop, and felt like the syncros were not working between gears.



The clutch was worn but still ok, but pilot was freezing up.



Replaced clutch & bearings - Shifts ok again.



This is just one possibility, but thought I'd through my experience out here for some input.



Some people will say check & change transmission oil, but unless its dangerously low, I doubt oil is the problem.



I do like the Southbend very much, but didnt like the price of getting it installed at the dealer. :--)

 

[greyghost]

Peter,



I would talk with Peter at SouthBend, the man know his stuff. Also talk with ATS they are an installer here in Denver, they may know of someone in Grand Junction, and Peter should have a list as well.



http://www.southbendclutch.com 1-800-988-4345 talk with Peter



http://www.ATSDiesel.com 800. 949. 6002



Hope this helps



Garrett