Computer Temp Guage Wiring?

[Archive]

There was a discussion a while back about using the factory computer temp guage wiring for another temperature sensor (transmission fuild, etc) and switching between the two sensors to have the temps displayed on the overhead display.

Has anyone done this? Where and what are the wires involved?

Anyone?

------------------
Y2K 3500, 4WD, Auto, 3. 54, Custom Brush Guard, Mopar nerf bars & rock guard, Camper package, Towing package, all options except leather, Mopar Rock Guards, Vent Shades, Solar Shade, RoseWood Dash, Air-Lift Air Bags, Hadley 'BULLY' air horns, Rancho RS9000s, Lance 1130 Camper

 

[Archive]

wcharlie,

It might be that the upper input range of the computer is too limited. Unless the temperatures are under about 108, you may exceed the scaling in the computer. I did see my system go 'bonkers' when the temp ran over that while in stop and go traffic between Las Vegas and San Diego last year.

------------------
<font color=#990000>~<font color=#990000> '99 2500 SLT <font color=#990000> ~ QC ~ 4X4 ~ LB ~ Auto ~ 4:10 LSD ~
<font color=#000000>*<font color=#990000> BD E-brake<font color=#000000> *<font color=#990000> BD Autolock<font color=#00000> *<font color=#990000> Gear Vendor OD<font color=#000000> *<font color=#990000> Jordan Research T-brake <font color=#000000> *<font color=#990000> Bullhide spray-in Line <font color=#000000>*
<font color=#000000>*<font color=#990000> 2k Komfort 5'er - 9,700 lbs <font color=#000000> *
<font size=-2>... Lookin' for the 'RE' to go in front of my 'TIRED' so's I got more time to Play!... <font size=-1>

[This message has been edited by Rattlin (edited 10-02-2000). ]