Engine adaptor plate torque spec?

[bgilbert]

Anyone got a factory service manual can tell me what the torque spec is for the engine adaptor plate w/getrag transmission? It bolts to the rear of the engine, the starter bolts to it. My Cummins manuals only give flywheel to crank, clutch, bell, and transmission torque specs. Thanks.

 

[DBF]

My 92 FSM shows these for the Diesel engine:



Trans mount Mounting to Trans (Manual) 50 ft/lbs

Trans mount Through Bolt Mounting (Manual) 50 ft/lbs

Transmission mounting to engine 30 ft/lbs

Transmission to Clutch Housing Mounting 35 ft/lbs



Flywheel Housing - Adaptor 44 ft/lbs

Flywheel Bolts 101 ft/lbs



You'll have to sort out the terminology - I've got an auto. I've left the obvious automatic specs out of this listing.



Regards, DBF

 

[PToombs]

Tighten with IR244 (air wrench) until they stop turning, perfect!

 

[bgilbert]

Flywheel housing is it, 44ftlbs. I went home and reread the book. Found it, I guess I wasn't looking in the correct place at first. They are thick bolts, but only have a 15mm head.