2nd Gen Non-Engine/Transmission Front Axle Nut

[radixr]

Hey, guys



Can anyone tell me what size socket I need to remove the front axle nut on a '96 4-wheel drive truck? What is the tightening torque when reinstalling the nut?



Thanks, DaveOo. Oo.

 

[mweiman]

I believe it is an 1 11/16", but I would have to check for sure.

Matt

 

[n7gxz]

You need a 1-11/16" socket of either a 3/4" or 1" drive. I use a 6" extension supported with a jack stand and a 3 foot cheater bar that I have to stand/bounce on to get them loose. If you have not fitured it out yet leave the tire on and the truck on the ground.



Kevin

 

[WilsonF]

If you need the torque:

Answers.com - What is the axle nut torque on a 96 ram 2500 4x4 with the 8800 lb axle

Floyd

 

[fest3er]

Torque to 172 ft-lb, then tighten until you can install the cotter key.

 

[DIESELWRKS]

and again have fun, have seen breaker bars break, gotta love the lifetime warranty.

if you have the time soak the nut a few times before.

 

[JPulliam]

I broke my 1/2" breaker bar when I did my ball joints. Plan to have a 3/4" breaker bar or a couple of 1/2" ones around. My 660 lbft IR impact got it off though ;-)

 

[wcjp]

Air impact tool usually has no problem.