Here I am

Fuel PSI gauge...Are you in the market?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Here's what the cylinder sleeves looked like after 140K miles.

Code P-1693

Status
Not open for further replies.
OK, here's the deal...



My lift pump was going south, so I had DC replace it. To keep this one good, I decided to go with the pusher pump setup. I ordered from Summit and while I was at it, ordered an AutoMeter Electric Fuel Pressure (0-15psi) gauge.



I installed the pusher pump and was going to install the AutoMeter next. I checked the pressure at the VP44 with my trusty AC+R gage and this thing will NOT go below 23-22psi at idle. I ordered another pusher pump (5psi, 72gph) and tried again. SAME THING (23-22psi).



So here I sit with a Brand New AutoMeter 4361 still in the box and never installed. If anyone is interested in it, let me know ASAP, because I will be shipping it back to Summit shortly, unless somebody wants it. I also have a Carter 7psi 110gph pusher. I can definitely hang on to it as a spare, but then again, if anyone is interested, let me know.



With all the talk about fuel gauges and pumps, I figured this may be the place for the post. And the total will be less than the total and shipping from Summit. :D
 
Status
Not open for further replies.
Back
Top