Here I am

2nd Gen Non-Engine/Transmission How Do Get The Muffler Off These Trucks

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
SOMEONE TOLD ME ONCE THE CLAMPS WHERE LOOSE TO TWIST THE MUFFLER AND IT WOULD POP LOOSE

IS THIS RITE

if it's that easy why go to a muffler shop
 
Last edited:
It usually ain't that easy. If you have access to a smoke wrench, you could heat it up and then twist it off. If you don't you'll need a cutting wheel or sawzall to cut it off.
 
If you have the factory muffler still on the truck, you'll have to cut it off. I used a sawzall. Worked just fine. Just remember to leave enough pipe to install the replacement to.
 
yes it's factory so you can't just twist and pull it off

the guy at the auto parts store told me you could twist it off

the geno's kit is a nice one once I get the muffler off it will be easy
 
twist it off... ha thats a joke i was using a hammer and slamming mine and it woudlnt even budge, rusted right on and its from texas
 
Going To The Muffler Shop Friday Get It Done Rite

How Much Do You Thank They Will Hit Me Up For $$$$$ To Do The Job

I Have The Geno's Pipe Kit
 
Some places might refuse to do the job because the Geno's pipe is a muffler elimination kit & they'll say that is illegal. Try the small, local guys in your area.
 
Status
Not open for further replies.
Back
Top