Here I am

IAT and MAP sensors on 2006 5.9?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

vibration in 5.9 l Cummins

Engine Missing

Status
Not open for further replies.

B.G. Smith

TDR MEMBER
Was going to check/clean the IAT and couldn't find but one sensor in the intake located on the top toward the rear??? bg
 
The Manifold Absoute Pressure and Intake Air Temp sensor is a dual funtion sensor situatuted on the top side of the intake manifold towrads the rear of the engine.

The Barometric Pressure and Air Intake Temp sensor is a dual dunction sensor location on the output port of the air box.
 
Thanks for the replies. I pulled the sensor this morning and it looked very clean. I was expecting to something that looked like the 99 IAT but it was just a black loop. looked like plastic coated but no build up. By the way, it takes a T-15 torx drive to remove. bg
 
Status
Not open for further replies.
Back
Top