Intercooler Fitting (Rubber Bootie)

[dkuehn]

Looking for a rubber bootie (connecter) from the intercooler to the pipe that runs to the turbo on the right side for a 1993 w250. The Dodge part number is 52006930, Hose Charge Air Cooler Duct. My air conditionining hose has almost rubbed a hole in mine. The dealer does not carry this part anymore Discontinued part. Where can I get one like it?



Thanks

Dan

 

[Philip]

Click on the Silcone Hump Hoses on this link.



http://www.ptrsds.com/silicone_turbo_hose index.htm

 

[willyslover]

Dan Try Piers. . he has a new HD boot for the 2 Gen. . but don't know if he has 1st Gens

 

[BushWakr - RIP]

Yes we do have HD boots for the 1st Gen trucks... please contact me off line or by PM...



Bob

 

[dpuckett]

Do they HAVE to be the hump hoses? Or will regular silicone turbo/ intercooler boots work? The reason I ask is that I will have to extend the tube going from the intercooler to the intake when/ if I get intercooled , and would rather run a little longer hose than have to weld on that thin stuff the tube is mads of.



Daniel

 

[sparks57]

Daniel, I'm sure you could make anything work.

 

[dpuckett]

I have, and plan to keep on doing so. Cant help it; southern upbringing, then rodeoing. I have no chance. Make do with whatcha got.

 

[prototech]

Hey guys,

I just replaced all of the boots on my intake system with 2 1/2" high temp silicone hose, cost was less than $25 at my local hydraulic hose shop and it works great and looks good too! you will need 2- 5" long pieces and 2- 4" long pieces, though I wish I had gone 5 1/4" long instead of 5" they seem to be a hair shorter than I would have liked. good luck.

Proto

 

[dkuehn]

Thanks Guys for your help!!! All I need to do is figure out what I want to do.



Thanks

Dan