parting out my 96 2500 man 4x4

[H_D98]

Parting out my old 96 dodge ram pulling truck, no engine.

Body is pretty well shot other than a bed, tailgate and drivers fender that I picked up for it.

Stainless nerf bars.

Dana 60 front, 80srw rear 3. 54 gears. Both have arb's and would like to sell together. Rear has one series heavier yolk and u joint, front has a billet yolk.

Ujoint can for rear end.

Springs are one ton that have been re-arched, and had 2 extra leaves added. This allowed me to pull the factory spacer blocks, and have it set level to eliminate axle wrap.

241dld transfer case for parts. Still works but pops out of 4 hi.

NV4500 that has been fully updated, big billet input, 5th gear fixed, cast rear housing, shifts flawlessly.

South bend 3600lb dual disk clutch, holds great, but center plate is worn and rattles. About $150 for a new one through them.

3rd gen chrome steel wheels with center caps.

Front receiver hitch with removable weight bracket.

12v ats 3pc manifold.

Fusion 12" subs in truck boxes that fit behind seat in a std cab.

Amp

Pioneer head unit, single disc, removable face, with remote.

Anything else you may need, ask, I might have it.

Can email pics.



Thanks!

 

[H_D98]

Clutch, trans, t-case, pedals and hydraulics sold tonight.

 

[91diesel]

what kind of price range are you looking for with the axles?

 

[DVolk]

I might be intersted in the intercooler and the pipeing ? possible the guage cluster if i could get it to fit a gen 1 truck , but then id need the dash wiring . , do you have any timing covers sitting around for 94 to 98 , i just need the sheetmetal only

 

[GKeller]

Do you have EGT, Boost & Fuel Pressure gauges?

 

[Cosmo]

You know this is a year and a half old thread, right?

 

[GKeller]

I didn't notice the original post date. I just saw activity from this year and it was very, very late at night. Thank you for the heads up. I'm new to the site as well.