Here I am

Engine/Transmission (1998.5 - 2002) peircing thje pump??

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

wired up???

  • killed the pump

    Votes: 7 6.4%
  • no problems for under 10,000k

    Votes: 25 22.9%
  • no problems for over 50,000k

    Votes: 49 45.0%
  • i will never pierce the pump

    Votes: 28 25.7%

  • Total voters
    109
  • Poll closed .

Engine/Transmission (1998.5 - 2002) Who has blown a HG

Status
Not open for further replies.
"Hooked the pump wire up killed the VP44 in about an 1/8 mile of 5x5 wot. "



I'd be VERY interested to have seen your fuel PSI to the VP-44 during that 1/8 mile - do you have guages?



VP-44's on 5x5, and no inlet PSI will go TU in rapid style!
 
Ha... ... . I have 2800 miles on my new lift pump. I have an autometer fuel PSI guage but havent installed it yet cause i just put on a new lift pump. It shut off so fast that my turbo barked. I had a five inch anhydros ammonia guage that i test with. (duct tape to the window, O YEAH) I put it on every once in a while just to check and make sure i have pressure. Usually it read 10-13 psi all the time.





I have a 105 gallon Lshape tank in my bed. I can select to suck off it or my factory tank. I can also select to return to it or my stock one. When I put on my new VP44 i will be adding a pusher after my solinoid valves. Just because I now have fuel mods.



Brian
 
Last edited:
Status
Not open for further replies.
Back
Top