Here I am

Pics and instructions for drill jig

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

NV5600 and Amsoil

Cruise control.

Status
Not open for further replies.
dustoff,
In answer to your question: "Has anybody thought of a class action lawsuit", the answer is yes... I am picking my truck up tomorrow night from my dealer, after many days of non warranty work, and will probably pay thousands of $$. Will not know until the moment I get at the dealers. So I asked "What is to prevent this from happing again?" His answer was, "The mechanic left it out". I thanked him for that answer. I also have asked if there is a TSB out on the dowel pin problem yet, and the answer is of course NO!

I also contacted Cummins and DC today and basiclly they said "Too bad, so sad, your dad". Oh by the way... They both said that they were VERY familiar with the TDR, so I invited them to log on and start reading some of the threads pertaining to the "Killer Dowel Pins".

I'm not stopping there... I am going for Consumer Protection Agency, State Attorney
General, Better Business Bureau and anybody else that will receive Email, letters, or phones calls, and will document all correspondence.

Do we have any attorneys out there in TDR land??? I could use some help/direction on where to go and who best to talk with.

Later, Probe

------------------
'94 RAM 2500 W/CUMMINS 5. 9... BANKS POWER PACK... K&N AIR FILTER... PRIMO OIL REFINER... AMSOIL SERIES 3000
 
Jeff, the jig kit is very complete. About the only uncommon tool you will need is a 1 7/16" open end wrench for removing the fan. A large adjustable end wrench might work for the fan, but I've never tried so I'm not sure.
 
John or Anyone,

If the jig comes around and all the screws are used up, what size do I need to get? I'm not sure what the screw is called.

I'll get a bunch & restock if needed.



[This message has been edited by HEMI®Dart (edited 05-22-2001). ]
 
How do i get the jig??
or meet someone who has it???

------------------
96 CC 4X4 2500 SLT AUTO transmission WITH TRANS-GO KIT, PrimeLoc, ISSPRO EGT Boost transmission Temp, GUTTED CAT, 187,000+ Miles still goin' strong, Lots of Ham Radio gear, NO IGNITION NOISE!!! Love my diesel!!! # 8 TST Fuel Plate. 20K 5th Wheel, Goose Ball, Reciever with all size balls, Pintle. We Haul to Please!!!
 
Status
Not open for further replies.
Back
Top