Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
TDR Magazine subscribers receive more than the magazine! You also gain additional forum privileges!
Details here: TDR Privileges
Subscribe to TDR Magazine here: https://www.tdr-online.com/
Attention: TDR Forum Junkies To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.
Does anyone have any idea why my power door locks will work unlocking my doors, but not locking? Both swithes are dead on the locking (down) side. Fuse is good. Any relays to check? Thanks for any help.
The locks operate with reversible electric motors attached to the latch mechanism. A failure in one will cause the other to fail as well. You'll have to disconnect them one at a time and see if the other becomes operative.
I have this same problem except it is reverse, if that makes sense. I am able to lock the doors but not unlock them. This is from the drivers side. The window controls work fine on the drivers side for both windows. The passenger side control does not work for the lock or the window. Any suggestions would be appreciated.
since we are on this topic i can lock from the passenger side, but not unlock. drivers side operates normal and windows are fine. i am thinkg about a dirty or bad switch in this cae.
I have a 98 and the lock switch works all the time on the passanger side but half time on drivers side. I called the local Dodge dealer and they stock the switch for the drivers side. He said they sell a lot of those switches. I purchased one but have not put it in yet.
I had a similar problem like the original post had. Had it fixed under warranty. Dealer said it was a connection that needed to be pushed back together.
Passenger power window would also go down but not up. I could get the window back up by working the switch and squeezing around on the black accordian boot at the door hinge. Apparently, the connection was inside the boot.
Loren ------ it is recommended to remove the plastic handle tray in the door and push the spring clip in on the back of the switch, you can pull the switch out by pulling up on one end of it (but this could damage the area where the clips hold at and leave slack in your switch when you replace it.
I have went through 3 driver switches and 2 passenger switches. At around 50 bucks a pop that gets pretty old. I took one apart last night and they have contacts inside that have a type of spring hinge which holds the contact open until you push the switch. It is possible these contacts are dirty and only need cleaning. Will clean one and try to see it will work again.
Which side is it? The spring clip on the drivers side is towards the front to the switch and the spring clip on the passanger side is towards the back of the switch.
you need to push the spring clip and pull up on the switch.
On '94-'07 trucks the window and door lock switches are all the same. If you have a bad one, try swapping it with another and see if it works differently. As these trucks age, you will see this come up again and again.
The window switches can cause an intermittant failure. It could be either switch but neither will work. Intermittant electrical issues are fun to diagnose too.