Option 1
Remove the filter head (FH'101) from the bag, take out all shipping plugs and Btow Att ports two blue plastic shipping plugs clean. Remove the from the solid end of the two fuel-hoses (plH-leo) and apply sealant to threads. (lf using Teflon tape for sealant, do not allow any tape over tne eno of the treads - loose tape can clog fuel galleys') Take this end of the hose and carefully turn into the hose adapter {HA-1og) on the remote head. Be sure to keep blue plastic plugs on other end of hose to keep free of dirt. Use a crowsfoot or regular wrench to tighten until snug' lf you are using a torque wrench tighten to zoN-m 1is ruru..1, Do not over-tighten.
Pp!!on2
After blowing the filter he'ad (FH-l01) ports elean place it in a vise equipped with soft jaws with the filter head stud (FHS-102) pointing up. coat both hose fitting threads (FAF-108) with pipe thread seatant (Teflon tape) and insta, the hose fittings into both threaded ports of the hose adapier (HA-1og) Tighten to 25N-m [20 futbs.]. (lf using Teflon tape for sealant, do not allow any tape over the end of the treads - loos" tape can clog fuet galleys.)
STEP 14
With the bracket now firmly mounted on intake manifold; peel back the plastic from the 4 holes in the narrow end of the bracket' (Do not remove more plastic than necess ary I ttiiuntfiltei head on bracket using the four (4) 3lgx16x3t4 stainless steel button screws (FHB-105). Be sure that t'ne z pJp" plugs are facing the front of the engine and the hose adapter is facing the rear. (see figure 4-to ensure propir ptacement.) using a 7t32 Altenwrench, tighten the 4 button screws evenly and torque io z5N--m [20 fulbs.]. n'ecoulr bracket with protective plastic until installation is complete. lrrrr I Y' ursvrl
STEP 15
Be sure to read fhis sfep carefutly. Remove the blue protective cap from the end of the hoses. lf you chose option 2 be sure to remove black tape before continuing. connect lhe center hoteof the filter adapter (FA-106) with the hole in the hose adapter (HA-l09) which is aosesttitni erqiii.'rnln connect the outside hoteof the filter adapter (FA- 106) to the outside hote of the hose adapte(HA-109); the rirtell-e"ai;;Gffiing on which option you chose (1 or 2); you will be connecting the swivel end of the hose to either the hose adapter (HA-1og) or the filter adapter (FA'I06) Route hoses in such a way as to not interfere with engine or vehicle operation. Tighten with 5/B and g/16 open-end wrenches' (Torque for hoses is 25N-m t2Oftllbsl.) getore compteting this step make sure the hoses are connected as specified above