Question on moog steering install

[JBergess]

Just purchased Moog parts #k992, to correct camber settings, but parts came with NO installation instructions at all. Anyone know torque specs for big nut, as well as which way bottom plate goes on? I noticed hole is off center-so has to go one way or the other.

Any way to set camber good enough to get it to shop-or just let shop install?









jbergess



90 w350 single rear wheels 2. 5 skyjacker system-rebuilt everything front end-every thing else original 225000(hard)mi

 

[ABrameloah]

MOOG K992 KIT

Hey JBergess do you have a fax number you can give me,I work for FED-MOG and that is our comp I have a copy of the sheet in front of me so I could fax it to you.

 

[JBergess]

moog

Thanks for reply-I don't have a fax-but you could e-mail me & attach My e-mail: -- email address removed --. Or just give me the particulars. anyways I apprecaite it.

 

[ABrameloah]

Moog K992 kit

Hey john hear is what I have for you. As far as the torque goes it will depend on witch set up you get(ther was a TRW unit-old style and the Moog new style)the TRW will have a small nut (5/8) and it will get torqued to 80-100 ft lbs and the MOOG new style will have a large nut (1 1/16 ) and will get torqued to 60-70 ft lbs both units have the four bolts that hold the plate on and thay will get torqued to 70-90 ft lbs. The plate will have a arow stamped in the edge and it will point to the wheel. I hope this helps you out.

 

[JBergess]

moog steering install

Yep-that's what I needed-but the plates I have don't have any arrows stamped on them. I guess mine are the old style, they have stamped on them:'Ingalls 600' model 60monobeam. Any way I probably can figure which way it goes once I pull it apart. I guess if the wheels are real crooked it must go the other way :-laf Thanks a lot for your help. If I run into any problem I'll let you know. I've already repalced upper and lower parts and hoped that would take care of it but camber was still out a little. So these should do the trick.





^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

1990 w-350

 

[ABrameloah]

MOOG K992 KIT

John if you don't have a arow or a v than the thin side of the off set goes to the wheel side.

 

[JBergess]

Good deal. That is definitely what I needed to know. Haven't installed yet but will soon. Any more questions I know who to loo k for-Thanks again--