Attention: TDR Forum Junkies 
I have 2 and 5/8" inside my control arm brackets. I have 3/4" heim joints with 5/8" reducer/misalignment washers and they both add up to 1 and 1/2".
What do you think I should use to make up the spaces on each side of the washer/reducers? It will be 9/16" each side. That's roughly four 5/8" flat washers each side, which I could do but is expensive and a waste, although my whole air ride system may seem like a waste, haha.
I could have some round spacer "washers" made out of 1/2" for one side and 5/8", since steel doesn't come in 9/16" thickness.
Any other ideas would be great!
Thanks, Nick
What do you think I should use to make up the spaces on each side of the washer/reducers? It will be 9/16" each side. That's roughly four 5/8" flat washers each side, which I could do but is expensive and a waste, although my whole air ride system may seem like a waste, haha.
I could have some round spacer "washers" made out of 1/2" for one side and 5/8", since steel doesn't come in 9/16" thickness.
Any other ideas would be great!
Thanks, Nick
