2nd Gen Non-Engine/Transmission Vent and Climate Control

[JGamble]

Hey all,



I just had a better clutch and flywheel installed at the Local AAMCO transmission place. When I dropped off the truck, the climate direction control (floor, mix, ac, dash, defrost, etc) worked like it was supposed to. When I picked it up today, every position on the control panel for the direction blew through the defrost vent ONLY #@$%!. WTH????? Any ideas out there? Thanks



Kind Regards,

John

 

[Moe]

You have lost vacuum somehow and the climate control will automatically default to defrost position. Check the vacuum line going under driver battery to the cruise control. Good Luck, Moe

 

[JGamble]

thanks, i will see tomorrow if they will cover it (hopefully so)

 

[LHastings]

I don't know about 01 but my 98 has a vacuum switch on the transfer case that controls the cad on the front axle. They could have left off the vacuum line going to your transfer case creating a big vac. leak.

 

[JGamble]

turns out that when changing the flywheel, they bumped a line and it disconnected. I brought it there today and it is fixed... . thanks again all.....



Regards,

john