Attention: TDR Forum Junkies The bearing on my water pump let go so I got a new one at the parts store. The only gasket it had was the rubber O-ring. I put the new pump in and ran the engine while I started filling it up. I noticed almost immediately it is dripping. Is there a gasket that goes around the whole outside edge, or is it just the o-ring? If theres just the rubber piece, I must've put it in wrong. 
Edit:
I found the problem. The O-ring wasn't quite seated right. On a somewhat related note, I picked up 2 gallons of Fleetguard Compleat coolant today, for the low low price of $67
I think I paid less than that for 3 gallons 6 months ago.
Aus
Edit:
I found the problem. The O-ring wasn't quite seated right. On a somewhat related note, I picked up 2 gallons of Fleetguard Compleat coolant today, for the low low price of $67
I think I paid less than that for 3 gallons 6 months ago. Aus
Last edited:
