2nd Gen Non-Engine/Transmission 3rd gen steering upgrade. Question for those who have done it.

[PToombs]

HH, you can buy just that bracket. I looked before and found them, about $190 IIRC. I can't remember where I found it, it was a couple years ago and I went with a Lukes Link because of the price at the time.

 

[HHhuntitall]

HH, you can buy just that bracket. I looked before and found them, about $190 IIRC. I can't remember where I found it, it was a couple years ago and I went with a Lukes Link because of the price at the time.

:-laf I've done the same thing!! I've been going to get the plasma torch out and make me a bracket for the frame, but time just hasn't allowed it. I've also looked at cutting the ball joint end off two 2nd gen tracking bars and fabbing up my own bar end with bushings... . Might not be real pretty but I bet it would work well. Then I could just put the bushings in each end when it needs it... . Also want to move the lower tracking bar location on the axle closer to the top and center of the axle so there's less angle to it..... that'll give me more f-l-e-x !!

 

[Bob4x4]

As long as it lines up with the steering link or bump steer city

 

[HHhuntitall]

As long as it lines up with the steering link or bump steer city

Yep, but what I had in mind was a little more aligned along the lines of big bumps anyway... .